I have an 04 R6, which rod am I supposed to cut to make it work as the installation manual doesn't show where from what I saw? Along with that is there a certain amount of threads that must be shown for the sensor to be 'clicked' or noticed? Just because mine is plugged in but is not recognizing that the shifter is being activated.

Question

I have an 04 R6, which rod am I supposed to cut to make it work as the installation manual doesn't show where from what I saw? Along with that is there a certain amount of threads that must be shown for the sensor to be 'clicked' or noticed? Just because mine is plugged in but is not recognizing that the shifter is being activated.

Status: Open Feb 08, 2023 - 03:53 PM

Do you have the same question? Follow this Question

1answer

Answer

Feb 08, 2023 - 04:21 PM

Hello Kaleb,
For an 04 Yamaha R7 you would need shift rods A & D with one of the pre-marked sections cut from shift rod D. For help with installation please reach us directly at pstech@dynojet.com

Browse by Topic