I have a 2007 r6s with a PCV. What quick shifter and rod(s) do I need to make everything work. Do I need to do any programming with my PCV to make the quick shifter work properly?

Question

I have a 2007 r6s with a PCV. What quick shifter and rod(s) do I need to make everything work. Do I need to do any programming with my PCV to make the quick shifter work properly?

Status: Open Mar 09, 2022 - 07:11 PM

Do you have the same question? Follow this Question

1answer

Answer

Mar 10, 2022 - 12:54 AM

Hello Dan,

Below are all the Quick Shift parts you will need for your 2007 R6S with PCV installed. Note: The Shift rods are recommend for the Factory rearsets/shift rods, if you have aftermarket rearsets/shift rod please let us know and we will revise your shift rod parts.

SKU: 4-130 QS Sensor: https://www.dynojet.com/quick-shifter...

SKU:L 32104060 Shift Rod A: https://www.dynojet.com/quick-shifter...

SKU: 32105030 Shift Rod D: https://www.dynojet.com/quick-shifter...
NOTE: We recommend to cut one section off to match your Factory shift rod length

Here is a direct link to enable/configure the Quick Shifter in the Power Commander V Software: https://dynojet.zendesk.com/hc/en-us/...

If you have any further question, please contact us directly at 1-800-992-4993 or email reply at pstech@dynojet.com. We are available M-F 8am to 5pm Pacific Time.

Powersports Technical Support
Dynojet Research, Inc.
Free: (800)992-4993

Browse by Topic