Answer
Jan 11, 2022 - 07:49 PM
Hello Viral,
Thank you for your support of Dynojet. If you have the PCV already then you will need the Dual contact sensor 4-130 and Shift Rod B 32104050 and cut 12mm off each end. After they have been installed you will need to enable the QS within the Power Commander Software. If you have any questions with this you can reach us at pstech@dynojet.com.
Thank you for your support of Dynojet. If you have the PCV already then you will need the Dual contact sensor 4-130 and Shift Rod B 32104050 and cut 12mm off each end. After they have been installed you will need to enable the QS within the Power Commander Software. If you have any questions with this you can reach us at pstech@dynojet.com.
