Hello there, I have a 2020 GSXR-750 and I already have the PCV. I need to get the quickshifter but wasn't sure which rod to get along with it. Any help is appreciated.

Question

Hello there, I have a 2020 GSXR-750 and I already have the PCV. I need to get the quickshifter but wasn't sure which rod to get along with it. Any help is appreciated.

Status: Open Oct 30, 2021 - 02:56 PM

Do you have the same question? Follow this Question

1answer

Answer

Nov 01, 2021 - 11:15 PM

Hello Ray,

Below are the parts you will need for your 2020 GSXR750 with the PCV installed.

SKU: 4-130 Quick Shifter Sensor: https://www.dynojet.com/quick-shifter...

SKU: 32104060 Shift Rod A: https://www.dynojet.com/quick-shifter...

SKU: 32104030 Shift Rod C: https://www.dynojet.com/quick-shifter...

NOTE: you will need to cut 3 sections of both shift rods and when you install the rods and QS Sensor together it should match your Factory Shift Rod length. Or if you have aftermarket rearsets/shift rods, you will need to measure your shift rod and minus 55mm (the length of the QS Sensor) and cut down the Dynojet Shift Rods to that measurement.

Then you will need to select one of three modules below to control the entire Quick Shifter Feature. You only need to select one additional module, not all three for the quick shifter to work properly.

SKU: QEM-12 Quick Shifter Expansion Module: https://www.dynojet.com/quick-shifter...

OR

SKU: SFM-3 Secondary Fuel Module: https://www.dynojet.com/power-command...

OR

SKU: 6-78 Ignition Module: https://www.dynojet.com/ign2-04-16-su...

??
If you need further assistance please contact us. Our technicians are available for customer assistance by email at pstech@dynojet.com or by phone at 800-992-4993 M-F 8-5 Pacific Time.

Powersports Technical Support
Dynojet Research, Inc.
Free: (800)992-4993
??

Browse by Topic