Question 1

This is a bit more technical ..... I have the pv3 kit i bought for my 2011 XL883L which is a 4 pin connector cable Po# PV3 15 01. I recently bought a 2020 XL1200ns. which uses the 6 pin connector cable Po# PV3 15 02... the head units look the same between the 2 kits... couldn't i just buy the 6 pin communication cable and an extra tune license and reuse the head unit i already have for my 2020? or are the head units different software? View answer

Answer posted 2 years ago

Question 2

I have a 2000 gsxr 750 with a power commander 3 usb among other upgrades and looking for a quick shifter. Can i get a list of all parts needed to install the quick shifter and have it fully functional on my bike? I would like to order all needed in one checkout. Thanks View answer

Answer posted 2 years ago

Question 3

can I eliminate the cam sensor with this unit ? View answer

Answer posted 2 years ago

Question 4

Have auto tune and target tune for some reason Check engine light comes on when bike is Italy. And not under load but as soon as I go. Wonder load or at continuous high-speed check engine. Light comes on for the 02 sensors. As soon as I decelerate or come to a stop check in engine goes off.Do a replace sensors or target tune. ? View answer

Answer posted 2 years ago

Question 5

On the Yamaha TW Kit, do you offer a few more mainjets than what's included in the kit? I need a size or two larger than a 130.Thanks, Paul View answer

Answer posted 2 years ago

Question 6

I have a 2012 VROD VRSCDX, will this system work with it stand alone? If not will I have to also purchase the Power Commander 5 (or equivalent since the V was discontinued)? View answer

Answer posted 2 years ago

Question 7

I bought a 2001 Honda Shadow ACE and came with a modified exhaust without muffler. Would this kit be suitable for aftermarket pipes? View answer

Answer posted 2 years ago

Question 8

I have several Harley?s (7) actually. Is there a product I can purchase that can be used with a PC to tune several different bikes. View answer

Answer posted 2 years ago | Target Tune for Harley-Davidson J1850 ECU 52/10'' 2P

Question 9

Can this device can remove the factory co2 probes to eliminate closed loop? View answer

Answer posted 2 years ago

Question 10

I?m looking for ignition module with quick shifter and power commander that is in advance View answer

Answer posted 2 years ago

Question 11

1,Can compatible 2021 super chief? 2, The incompatibility with Scout models,Because different cable connectors?Thank you! View answer

Answer posted 2 years ago

Question 12

If I order this part number from my local dealer, does it come with this basemap pre installed? If so is the map any different from stock? View answer

Answer posted 2 years ago

Question 13

I have a 2010 cbr 1000rr with a PC5. What shift rod do I need for the quickshifter? View answer

Answer posted 2 years ago

Question 14

What ist the Power Commander VI shipping time?Delivery to switzerland. View answer

Answer posted 2 years ago

Question 15

Hey, I have an 06 cbr 1000rr with a full two brothers exhaust. It has a dead spot at low end because of not being tuned for the exhaust. Would the 6 be able to throw enough fuel at it to fix that? And what keeps the 02 from just pulling that fuel back out? View answer

Answer posted 2 years ago

Question 16

Does this operate similar to the PV3 in that it removes the speed and RPM limiters? Is it with a simple tune, or is it more complicated? View answer

Answer posted 2 years ago

Question 17

Why would you sell a product with little to no value? The PV4 is my first DJ product marketed by Fuel Moto as the next best thing. It offers zero value beside Bluetooth. Big flippin deal. When will meaningful features come out like like compatibility via the cloud with Winpep or auto tune without having to buy additional hardware? View answer

Answer posted 2 years ago | Power Vision 4 for 2011-2020 Harley Davidson

Question 18

Can i run this without a tsm/tssm? Also this is for a racing application. Can this be shipped to California. View answer

Answer posted 2 years ago

Question 19

Will this work on my 1976 HD FX kick-start only model? View answer

Answer posted 2 years ago

Question 20

Do you have any maps for simple exhaust change and low speed surging? Or user uploaded maps for the Yamaha xvs1300? View answer

Answer posted 2 years ago

Question 21

Can this eliminate the tssm,02 dyna is what I'm fixing. View answer

Answer posted 2 years ago

Question 22

Will the singular license that comes with the purchase allow for installing and switching tunes on the same vehicle? View answer

Answer posted 2 years ago

Question 23

I bought a PCV for my 2002 Honda VTX 1800 S motorcycle. I would like to know if the POWER COMMANDER POD-300 DISPLAY is compatible. View answer

Answer posted 2 years ago

Question 24

I have a 2005 gsxr600. I am buying a pc6 for it and want to install quickshifter as well. Is this the one I would buy and what else would I need for any kind of sensors and shift rods? View answer

Answer posted 2 years ago

Question 25

Is the AT200 comparable with the 2014 Royal Enfield Continental GT 535 Cafe or is there a specific AT200 for the RE Continental GT 535?My GT 535 does have the Power Commander V installed. View answer

Answer posted 2 years ago

Question 26

if i put this on full power and try to launch it will it give me a power wheelie and i have never had a bike higher then a 300 but i wanted to move up to this since i had he 300 for years. i do not know how to control this amount of power if you could tell me if it would give me a power wheelie and how to stop it from doing that but still giving me the fastest launch possible it would be much appreciated View answer

Answer posted 2 years ago

Question 27

Will this work on the 2023 570 xmr ? View answer

Answer posted 2 years ago

Question 28

Hi. This is in reference to SKU# DS6-1 to be installed on 1998 FLSTS HD.1. There is not a download on the website for the instructions. Can you email them to me or I do I get access to the installation instructions.2. It appears by the photo on the website that it has two wires, is this correct?3. Where do the wires connect to? Or if you can provide the wire instructions this question is not required.4. What do I do with the three wires going from my ignition module to my currect cam position sensor?5. Do I need to purchase any other parts to ensure this new cam position sensors works with my bike? Note, I have all stock parts on my bike.Thank you,Hank View answer

Answer posted 2 years ago

Question 29

My 2023 Road Glide 3 is not listed for use on the POWER VISION 4 or the POWER VISION. (The one with the LED screen) Will this be updated shortly? Thanks View answer

Answer posted 2 years ago

Question 30

Will the dual channel kit work with a 2014 Honda Valkyrie with PCV? I'd like to run one for each cylinder bank like stock, but the documentation suggests that the PCV will see these as 2 separate single cylinders as opposed to the 2 banks of 3 cylinders the bike has. Please clarify. View answer

Answer posted 2 years ago

Question 31

I have the pv4 for the renegade 1000 and I'm going to need an additional license for another renegade but I'm seeing a license for the pv4 or will the pv3 license work for it View answer

Answer posted 2 years ago

Question 32

Good day, do you have a power commander for kawasaki z1000r 2023 model? View answer

Answer posted 2 years ago

Question 33

I have an old chrome PV part # 1020-1494I have a 2021 HD touring model that has a PV licensed tune. Will this cable work with my old display unit on this bike? View answer

Answer posted 2 years ago

Question 34

I didn't see a 2021 Ryker ACE listed in the fitment list. Is it compatable to clear code with a 2021 Ryker ACE Not a Rally? If so where and how do I purchase. I have a 37873 zip in TennesseeThanks for you time. View answer

Answer posted 2 years ago

Question 35

Ihave a Suzuki GSX-Ss750 2018 what i would need to only have the quickshift feature?if you could make me a list i would really appreciate it.ThanksJR View answer

Answer posted 2 years ago

Question 36

Are the Power Commander 6s capable of adjusting timing on Victory motorcycles below 2500rpm? View answer

Answer posted 2 years ago

Question 37

hello there,The $178.00 is for a pair or just one?Thank you. View answer

Answer posted 2 years ago

Question 38

Will this require me to upgrade the stock clutch on my 2022 Can-am Commander 1000R? View answer

Answer posted 2 years ago

Question 39

How much data can you record on this? How long of a ride can I record? View answer

Answer posted 2 years ago | Power Vision 4 for 2021 Harley Davidson

Question 40

Will they come out with a PV4 for a Yamaha MT-07? View answer

Answer posted 2 years ago

Question 41

Hello! Is the power Vision designed to send the tune to the motorcycle and then disconnect, or does it have to stay connected? I want something that I can hook up, send the tune to the ECU and disconnect. Thanks! View answer

Answer posted 2 years ago | Power Vision for Harley-Davidson Flash License

Question 42

Hi guys Ive fitted this to my MT-10sp, is there a different one for the sp model, because im getting suspension faults and a spanner light on the dash. View answer

Answer posted 2 years ago

Question 43

Does this fit mule 4010 2023? Thank you, View answer

Answer posted 2 years ago

Question 44

Why is it you don't recommend the 3 ohm coils for street use... is it harmful in some way or have a lower service life... or is it simply just because it's an overkill? View answer

Answer posted 2 years ago

Question 45

Hello,Models go up to 2021, but would this be adequate for a 2023?Thanks View answer

Answer posted 2 years ago

Question 46

Does this work with RDRS View answer

Answer posted 2 years ago | PV3 Autotune Kit (with Bungs) for Harley-Davidson CAN ECU

Question 47

I had a legit business bike mechanic install the Power Commander 6 on My 21 Indian Challenger with a stage 1.He couldn?t take the speed limiter off that governs to 112 mph max.Does the PC6 have the capability of removing the governor or overriding it?I spent about 500 to make my bike have the 150 mph capability. Very disappointed & I don?t want to spend another 500 for the Power Vision to override the governor. Not interested in sending in the ECM to get it flashed either. I live between Fresno & Los Angeles, Ca., is there a shop you could recommend I ride over to for flashing off the governor ? View answer

Answer posted 2 years ago | Power Commander 6 for 2020-2022 Indian Motorcycle Challenger

Question 48

I have a 2021 outlander 650 xt there is no option? do i select one thats under 2023?? View answer

Answer posted 2 years ago | Power Vision 3 for Can-Am Outlander

Question 49

Do you have to get this programmed or when I get this ICM can I just put it on my bike and ride. View answer

Answer posted 2 years ago

Question 50

This may sound dumb, but can it read and clear DCT's, or is it strictly a flash tuner?I have friends who have the pv1 and it still works great for them.I know I can get an adapter cable for Polaris/indian and use a regular obd2 scanner, but I want an excuse to buy this to flash tune ???? View answer

Answer posted 2 years ago

Browse by Topic