Question 1

Will this work on a '22 Low rider S? View answer

Asked 11 ´months ago | POWER VISION FOR 2021+ HARLEY-DAVIDSON

Question 2

whats the difference between PV3-29-02 vs PV3-2902C??? View answer

Asked 11 ´months ago

Question 3

Does the PV3 need to stay connected to the vehicle to be able to use the Active Power Mode Switch? View answer

Asked 11 ´months ago

Question 4

Does this have a tune for 2023 models? Says "Power Vision 3 for Honda CB650 / CBR650 has tunes, see below"NO TUNES AVAILABLE... View answer

Asked 11 ´months ago

Question 5

Does this need upgraded 8mm suppression core spark plug wires? Or the stock 7mm copper core wire? View answer

Asked 11 ´months ago

Question 6

On my bike, I have been struggling with power, it?s stock. A homie messed around with it before I had it to make it shoot flames on the stock carb. I don?t care for flames, I would like my power back. Runs rich. I have to replace the secondary diaphragm cover cause it?s very cracked, the intake boot also falling apart, and the float bowl only had three screws in and was leaking. I?m hoping repairing this will fix my issues, but was wondering, would it be better to install this jet kit on a 42mm mikuni performance carburetor for better power? Or stock carb is better? View answer

Asked 11 ´months ago

Question 7

Does this coil need to be bolted with standoffs and to the frame? I am looking to replace my OEM coil on my 1976 KZ400 as well as moving the location of it, but the place that I found that will be perfect is not a section of frame or connected to the frame. View answer

Asked 11 ´months ago

Question 8

Your Question: I've got a turbocharged Hayabusa 2002. Is this ignition module compatible with the Power Commander V for the Hayabusa 2002 - 2007 Turbo (20-023-PTI) and with my bike? View answer

Asked 11 ´months ago

Question 9

Does this product need a PC6 or FC to be used? View answer

Asked 11 ´months ago

Question 10

Do I need to buy 2 kits for my Marauder VZ800, or does one kit come with the parts for both carburetors since the motorcycle has 2? View answer

Asked 11 ´months ago

Question 11

I just purchased a pv4 for can am outlander 850 xmr and was wondering if I can get a custom tune made View answer

Asked 11 ´months ago | Power Vision 4 for Can-Am X3 Pinout

Question 12

The end piece that threads on to the wastegate where it connects to the turbo has broken on my dynojet waste gate. How might I go about getting a replacement? Is there a part # I can order it? It looks like it has now been upgraded to a heim joint on the ones you now sell. View answer

Asked 11 ´months ago

Question 13

Where do i find tunes for aftermarket pipes and snorkels View answer

Asked 11 ´months ago | Power Vision 3 for Can-Am Outlander

Question 14

2023 maverick x3 xor turbo rr 64" with 35" tires.will it work for it? View answer

Asked 11 ´months ago

Question 15

Does the kit come with parts for all four carbs? Or do I have to buy four kits? View answer

Asked 11 ´months ago

Question 16

Hi. I have bought an power commander V for my 1999 Hayabusa, but there is round white connectores on the bike, but square black connector on the PW. What to do? View answer

Asked 11 ´months ago

Question 17

Hi , What about STAGE 3 KIT FOR INDIAN THUNDERSTROKE 111/116 ?Not in stock now , soon available ?Delivery for France possible ?Best regards Olivier View answer

Asked 11 ´months ago

Question 18

Hi, mostly interested because I might get a 180 or 200cc kit and bigger injector for it in the future. My questions - there seems to not be any maps related to bigger cc engines as downloads, will I be able to create a full map for these bigger cc's since I'm only limited to 15% adjustment in fuel? Or do I have to keep adding fuel and create a new map as base map until I get to were I need to be? Does the pc6 alow me to manipulate ignition timing? I know I can create a fuel compensation map off of a 0-5v analogue pressure sensor input in the manifold but can I xxxx timing well? The bike in question is a '11 yamaha yzf-r 125. View answer

Asked 11 ´months ago

Question 19

Does it come ready to install? View answer

Asked 12 ´months ago

Question 20

Does this adaptor work with the snap on solus plus scan tool? View answer

Asked 12 ´months ago

Question 21

Can this be used to bleed the ABS module through the ECM? View answer

Asked 12 ´months ago | Power Vision 4 for 2021 Harley Davidson

Question 22

What size Jets come in the Klx 110 jet kit?? View answer

Asked 12 ´months ago | Jet Kit for 2010-2023 Kawasaki KLX110

Question 23

Is the tuner water proof? Does it have warranty? And if I were to install it now without an aftermarket exhaust and install one later would the tune be good to run or would I have to re tune it? View answer

Asked 12 ´months ago

Question 24

Your quick shifter run on FXLRS 2020 ? Should we install another module (as power commander) ? It works with mid control ? View answer

Asked 1 ´year ago | PCIIIUSB HD QS Sensor Kit,99-08,Softail

Question 25

I have a power commander three in my 2006 ultra classic I cannot figure out why my rear cylinder is running really hot. I mean really hot. It is duals with Rhineharts. When I look at my setting on my power commander it looks like it?s lean 00 at low, but I can?t make any adjustments to this xxxx thing anybody help View answer

Asked 1 ´year ago

Question 26

Will this work with PV-3B? The instructions only show the small screen model. 2021 FLSB lvl 28 softwarePowervision PV-3B View answer

Asked 1 ´year ago

Question 27

Is this ignition module self-grounding? I blew the stock ignition module and switched over to points. Which had grounding issues. Just want to get this squared away before I install it. View answer

Asked 1 ´year ago

Question 28

Hello, will this work on the BMW F750 GS? From everything I have seen they are the same engine with a limited ECU on the 750. View answer

Asked 1 ´year ago

Question 29

is this the cable i need for a 2011 road king? View answer

Asked 1 ´year ago

Question 30

Are the pre-terminated ends 90 degree bends? View answer

Asked 1 ´year ago

Question 31

Does it matter which side of the coil is 12+ and ignition? I know the white wire goes to the 12+ and the blue goes to the opposite side, but the bike has been completely rewired and I'm not sure which wire goes on which side. View answer

Asked 1 ´year ago

Question 32

What connector kit do I need to program with the curvemaker software?I have the DDK1-5C View answer

Asked 1 ´year ago

Question 33

I have a 2022 Fat Bob 114 FXFBS, does this tuner work with it? View answer

Asked 1 ´year ago

Question 34

I have bought a PV3-15-01(2001-2017)for my bikes ,i have a friend that bought a 2019 Street Glide and need a PV3-15-02 is the PV3-15-01 will be compatible if i replace the plugin or he will need the complete module ? View answer

Asked 1 ´year ago | Power Vision 3 for 2001-2017 Harley-Davidson J1850 ECU

Question 35

just wondering if it has to stay plug in after you run the scan because my reverse lights run threw the same plug in. also does it void any factory warranty View answer

Asked 1 ´year ago

Question 36

Can I use 2,2ohm coils with the dyna S? View answer

Asked 1 ´year ago

Question 37

Does this system remove the speed limiter? View answer

Asked 1 ´year ago | Fuel & Fire Kit for 2005-2008 Suzuki LT-Z400

Question 38

Will this eliminate the speed limiter? View answer

Asked 1 ´year ago | Fuel & Fire Kit for 2005-2008 Suzuki LT-Z400

Question 39

Does it work for tenere 700 2024 its not listed on the model coverage list View answer

Asked 1 ´year ago

Question 40

Can delete or reset wrench indicator from ABS bleed counter? View answer

Asked 1 ´year ago | Power Vision 4 for 2021 Harley Davidson

Question 41

Dies the wideband kit work with the PV4? View answer

Asked 1 ´year ago

Question 42

Does the bikes traction control continue to function when using a Power Commander 6 and a custom tune? View answer

Asked 1 ´year ago

Question 43

If I upgrade the clucth or the exhaust is there a way to upgrade the tune. Is this program flexible as we add upgrades. View answer

Asked 1 ´year ago

Question 44

Can you please differences between Carburettor jet kits SKU 1139, 1139CA and 1139HA?Interested in a jet kit for a track VFR750.Regards, Craig L View answer

Asked 1 ´year ago

Question 45

If I buy this device and wanted to get the unlocked license version how much would that cost? View answer

Asked 1 ´year ago | Harley-Davidson Power Vision Delphi CAN ECU Black

Question 46

Is this kit for just one carb or both of them? View answer

Asked 1 ´year ago

Question 47

I have a PV4 from a RK that has been sold. If I buy a license, will my pv4 record and save the OEM on the new bike. View answer

Asked 1 ´year ago | Power Vision for Harley-Davidson Tuning License

Question 48

Can the PV4 be connected and used with a Samsung galaxy tablet for flashing and displaying the real time gauge data? View answer

Asked 1 ´year ago | Power Vision 4 for Can-Am X3 Pinout

Question 49

Is their any way to make these quickshifters work with the powervision tunes and not the Power commander? View answer

Asked 1 ´year ago

Question 50

Do u guys have a stage 2 or 3 not just stage 1 for the 2004 Suzuki GS500F View answer

Asked 1 ´year ago

Browse by Topic