Question 1

I am doing a 2007 XL1200C EFI to Carb Swap, will this ignition work? View answer

Asked 2 ´years ago

Question 2

I?m looking to purchase a complete kit to add onto my cbr 600 f4i do I need to just buy the dual sensor and shift rod b ? And everything will work then or what ? Thanks again ! View answer

Asked 2 ´years ago

Question 3

Can this remove the rpm restrictions? View answer

Asked 2 ´years ago

Question 4

Hellocan i command this for France, no more sellers for this parts in my country....how i can buy it?Thanks View answer

Asked 2 ´years ago

Question 5

My original CDI has 3 cables attached and this box only has 2 ports will it work on my 2006 grizzly 660 View answer

Asked 2 ´years ago

Question 6

How how exactly does the wiring for the injectors work? If I'm using this product on a 4 cylinder engine will I have to solder a different hardness to make it compatible? View answer

Asked 2 ´years ago

Question 7

Does it fit CRF 300 rally EURO model? (ecu part number 38770-K1T-E11) View answer

Asked 2 ´years ago

Question 8

I have a 1974 fx with STD dual plug heads.(didn't order dual but that's what they sent) Been running as single with points for 20yrs. Tried duals coils years ago but the condenser couldn't keep up. What coils would I need with this ignition I see your single fire needs 5ohm coils. What coils will this dual fire use? View answer

Asked 2 ´years ago

Question 9

Do you have any solution that works with the EU ECU of the CRF300L? View answer

Asked 2 ´years ago

Question 10

I have this unit on my 2022 KLX300R. Can you tell me if it's controlling only fuel, or fuel and ignition ? View answer

Asked 2 ´years ago

Question 11

How long a duration of data can be logged in the POD-300 and can that data be exported to Excel, Matlab, etc? View answer

Asked 2 ´years ago

Question 12

Does this fit on a 2022 can am renegade xmr View answer

Asked 2 ´years ago | Power Vision 3 for Can-Am Outlander

Question 13

When the throttle commander will be available for can am 2023 View answer

Asked 2 ´years ago

Question 14

Which ignition coil should be purchased for use with this on a 77 kz650? I want to make sure I have the right ohms. View answer

Asked 2 ´years ago

Question 15

Hi. Do you have a power commander that fits my 2019 Lynx Xtrim 850 E-TECH? is it maby the same as used on the ski-doo 850 E-tech ?? Is there any big different on the PCV and the new PC6? View answer

Asked 2 ´years ago

Question 16

I have a PV-1B. will firmware update, new license, and this cable let it communicate with my 2021 low rider s View answer

Asked 2 ´years ago

Question 17

Can you use the 2510C on a 2023 outlander? Or does it have to be the 25?10 View answer

Asked 2 ´years ago | Power Vision 3 for Can-Am Outlander

Question 18

I would like to have the assembly instructions as for the power command V. Thanks View answer

Asked 2 ´years ago

Question 19

Wll the jet kit for the 2005 yamaha yzf 600r (4145) work for a stock motor but no airbox (individual air filters?) View answer

Asked 2 ´years ago

Question 20

I have a HighBall 2016, does this fit it? It says it fits 09-15 and mine is 16? View answer

Asked 2 ´years ago

Question 21

This kit should be good for a banshee since it has 2 carburators?? View answer

Asked 2 ´years ago

Question 22

For a 2017 dr650 instructions say 170 main for aftermarket exhaust. People online are using 160. View answer

Asked 2 ´years ago

Question 23

Good afternoon My AK M800 SP 2013 has PCV installed, the firmware is standard, and a full slp exhaust is also installed. I can?t find the firmware for this exhaust, will installing autotune help me to adjust the fuel mixture and eliminate dips at low speeds? Thank you. View answer

Asked 2 ´years ago

Question 24

I have a 2011 CBR250R that I enjoy working on. I'd like to add a Power commander V but it is discontinued. Any chance there is one there for purchase? View answer

Asked 2 ´years ago

Question 25

Hi, what is the difference between SKU PC6-18025 and SKU PC6-18024 ? View answer

Asked 2 ´years ago

Question 26

I have a Gsx-r600 and would like to install a Bi-directional quick shifter. What rod and quick shifter would be necessary for that application? View answer

Asked 2 ´years ago

Question 27

Helloi want to buy suitable product for my car indian scout 2017thank you so much!NAM View answer

Asked 2 ´years ago

Question 28

I have 2013 HD switchback, with a Samson 1 into 1 exhaust and S&S air cleaner. I will be adding a Woods 222 cam to the bike, what would be the best tuner with auto tune for this application View answer

Asked 2 ´years ago | Harley-Davidson Power Vision Delphi CAN ECU Black

Question 29

buenas tardes, que bobina me recomiendan para este sistema de encendido? dos entradas (bateria y encendido) y una salida?Es una Moto Guzzi T5 1994Gracias View answer

Asked 2 ´years ago

Question 30

Will the PV4 fit my 2023 scout bobber sixty? View answer

Asked 2 ´years ago

Question 31

What is the difference in the blue and red label units with the same part #'s?Thank you! View answer

Asked 2 ´years ago

Question 32

What is the best location on the stock header for a 2000 electraGlide ultra. I'm going to use the Dynojet WB O2 sensors. View answer

Asked 2 ´years ago

Question 33

Do you have CV carb jet kit for a 120" Jim's engine View answer

Asked 2 ´years ago

Question 34

When i buy this license, Dynojet will send to me Digital Token or physical Token card? View answer

Asked 2 ´years ago | Power Vision for Harley-Davidson Flash License

Question 35

What is the difference between PV3 2510 and 2510C View answer

Asked 2 ´years ago | Power Vision 3 for Can-Am Outlander

Question 36

This PCFC is now compatible with the 2024 KLX300?Also, can I just use this fuel controller settings as is or do you need to always downs map from the site? View answer

Asked 2 ´years ago

Question 37

Does this work with the can am module for snow tracks? View answer

Asked 2 ´years ago

Question 38

Dear Ladies and Gentlemen,I bought the PCV for my Yamaha XV 950 with the Vance and Hines Twin Slash Staggered exhaust and the VO2 air filter also from Vance and Hines. After loading and installing the New Map the machine starts, but the speed is only in the range between 700 and 800 rpm and the machine goes off again if I don't turn on the gas tap. The engine control lamp also lights up. As far as I know, I have connected all the cables as indicated in the instructions and now I do not know any more. Therefore, I ask for your help to solve my above mentioned problem. Thank you and best regardsJannis H�fel View answer

Asked 2 ´years ago

Question 39

Is it possible to ship to Korea? I'm trying to place an order, but the shipping fee is not being calculated. View answer

Asked 2 ´years ago

Question 40

Could you please tell me the difference between there two tuners, they both fit my machine.SKU#PV3-2516CSKU#PV3-2516Thank you?. View answer

Asked 2 ´years ago

Question 41

Hi i am wanting to get a PV3 for my 2022 TRX520FA6 but your website does not list this model is the trx520 pv3 and tune compatible ? View answer

Asked 2 ´years ago

Question 42

I running a PC6 on an 05 FXDWGI and looking to add an autotune kit Will this work? The description only refers to PC5.POWER COMMANDER AUTOTUNE FOR HARLEY-DAVIDSON WITH 4-PIN CONNECTORS (WITH O2 BUNGS)SKU#AT-100BThanks, Mark View answer

Asked 2 ´years ago

Question 43

Even though it says the PV3 fits a 2020 renegade 1000R XXC, Is there a better option View answer

Asked 2 ´years ago | Power Vision 3 for Can-Am Outlander

Question 44

After installing my Dynatek ignition can i remove my stock ignition module or does it control other things too 1994 Dyna ide Glide Thanks View answer

Asked 2 ´years ago

Question 45

I sold my current bike and purchased a new one. Can I transfer the license from the old bike to the new one? I will only have the new bike and don't need multiple licenses. View answer

Asked 2 ´years ago | Power Vision for Harley-Davidson Flash License

Question 46

Hi,I recently purchased a used 2013 Triumph Thunderbird Storm (1700 w/abs). I see a PCV is listed for this bike for 2010-2014 (SKU 21-001) but is discontinued and out of stock. But I also see SKU PC6-21019 (in stock) fits my bike for model years 2014-2015. So if a unavailable one fits my bike and is for 2010-2014 and available one also fits a 2014 I would think it may fit for my 2013? Please let me know if this PC6 would actually fit my 2013?Thanks, Scott View answer

Asked 2 ´years ago

Question 47

Will this work with a 2012 Cvo street glide View answer

Asked 2 ´years ago | Harley-Davidson Power Vision Delphi CAN ECU Black

Question 48

Can the four output coil (DC6-4) be used with points ignition for a dual plug conversion? View answer

Asked 2 ´years ago

Question 49

i have a 2005 zx10r and was thinking about getting a quick shifter, what other parts or rods would i need to do this? View answer

Asked 2 ´years ago

Question 50

It's a pretty good basic tuner if just doing Air and pipes. using a data logger and then making adjustments is long and tedious work, The Tune turned out really well. Not everyone is capable, just like not everyone has access to a Tuner with a Dyno or one that can be trusted! So where is the auto-tune feature? View answer

Asked 2 ´years ago

Browse by Topic