Question 1

Will it fit 2002 Blackbird? Because the PCV page for BB sends you to this item, but here show the disclaimer that it does not fit my bike. However, on the previous site it says that this product superseeded the PCV for 2002 Blackbird. I just wanna get some clarification. Thanks. View answer

Answer posted 1 year ago

Question 2

Hello, do your quick shifters allow for clutchless up and down shifting? Thanks. View answer

Answer posted 1 year ago

Question 3

I have a power commander 6 can i install a target tune or does this require a power vision? View answer

Answer posted 1 year ago

Question 4

hello, I have PV for my RK2009 and I would buy a new licence for my XL883, how does works the installation of the new license? View answer

Answer posted 1 year ago | Power Vision for Harley-Davidson Flash License

Question 5

Does this tuner come with the wide and o2 sensors? If not is there a way to add them? View answer

Answer posted 1 year ago | Harley-Davidson Power Vision for Delphi J1850 ECU Black

Question 6

I have a 2023 raptor 700r se and wanted to know with the tuner will my top speed increase? My bike is stock right now so does it come already programmed for that? View answer

Answer posted 1 year ago

Question 7

I am thinking about purchasing a cb650r lams thats been unrestricted and would like to revert back to a restricted setup whilst on my learners. Id like to save the current flash for once I have my full licence and flash the lams restricted tune onto the bike. Do you have a lams ecu tune and is this possible?Thanks View answer

Answer posted 1 year ago | Power Vision 3 for 2014-2020 HONDA CB650

Question 8

If you have a dyno tune loaded for a raptor 700 would this still work. I ride at 5000 ft elevation and at sea level. So I would like the tune to be better at the elevation. I have a pc5 now that was dyno tuned. It?s a bigger motor different exhaust cams custom head piston and compression etc. so for the base parameters for air to fuel ration are they adjustable ? So your customer tuner can set these ratios? View answer

Answer posted 1 year ago

Question 9

Will this fit a 2017 harley davidson fxdf fat bob dyna? View answer

Answer posted 1 year ago

Question 10

The listing shows compatibility with quickshifter, but it doesn?t look like there?s one available for the scrambler 1200. Is there one that works? View answer

Answer posted 1 year ago

Question 11

Does this come with each jet? Is a slow jet included? View answer

Answer posted 1 year ago

Question 12

Will this work on a 2022 H2 SX SE? View answer

Answer posted 1 year ago

Question 13

I have a PV3 with 2 tunes on it that are licensed to my 2022 CanAm Maverick X3. Can I purchase additional licenses and use my PV3 to tune my friends machines as well (with one of the 2 tunes I have already) on their X3's (there's 9 of us in our group and all machines are 2019-2023) View answer

Answer posted 1 year ago

Question 14

After purchasing a new license, is it required to purchase any other additional cabling? Or is it as simple as loading the additional license onto the tuner and plugging it in? View answer

Answer posted 1 year ago | Power Vision for Harley-Davidson Flash License

Question 15

Using invision on my 23 challenger. Will this unit be vin locked to my bike only or can I use on any other bike. View answer

Answer posted 1 year ago | InVision Monitor Device for Indian Motorcycle MG1

Question 16

How can ?autotune? be used without O2 sensors installed? View answer

Answer posted 1 year ago | Harley-Davidson Power Vision Delphi CAN ECU Black

Question 17

How many tunes come preloaded on the tuner View answer

Answer posted 1 year ago | Power Vision 3 for 2001-2017 Harley-Davidson J1850 ECU

Question 18

Does the power vision 3 read and clear codes View answer

Answer posted 1 year ago

Question 19

Can PV4 be used with H-D auto tune kit AT-110 ? View answer

Answer posted 1 year ago

Question 20

What size is the kit ? View answer

Answer posted 1 year ago

Question 21

So I have a 2003 gsxr 1000 and wanna get a quick shifter for it but also want to get a power commander as well what would be the best setup? View answer

Answer posted 1 year ago

Question 22

Can I use this to remove the 35kw ECU restriction on my mt-07 2023? View answer

Answer posted 1 year ago

Question 23

Can I use this tuner to put a "child" mode on my xp turbo, I was hopping to lower the horsepower to roughly 80hp and lower the speed limiter to 30-45 mph, could I do that with this tuner?And is the super atv tuner the same as this one? View answer

Answer posted 1 year ago

Question 24

Will this work on a '22 Low rider S? View answer

Answer posted 1 year ago | POWER VISION FOR 2021+ HARLEY-DAVIDSON

Question 25

whats the difference between PV3-29-02 vs PV3-2902C??? View answer

Answer posted 1 year ago

Question 26

Does the PV3 need to stay connected to the vehicle to be able to use the Active Power Mode Switch? View answer

Answer posted 1 year ago

Question 27

Does this have a tune for 2023 models? Says "Power Vision 3 for Honda CB650 / CBR650 has tunes, see below"NO TUNES AVAILABLE... View answer

Answer posted 1 year ago

Question 28

Does this need upgraded 8mm suppression core spark plug wires? Or the stock 7mm copper core wire? View answer

Answer posted 1 year ago

Question 29

On my bike, I have been struggling with power, it?s stock. A homie messed around with it before I had it to make it shoot flames on the stock carb. I don?t care for flames, I would like my power back. Runs rich. I have to replace the secondary diaphragm cover cause it?s very cracked, the intake boot also falling apart, and the float bowl only had three screws in and was leaking. I?m hoping repairing this will fix my issues, but was wondering, would it be better to install this jet kit on a 42mm mikuni performance carburetor for better power? Or stock carb is better? View answer

Answer posted 1 year ago

Question 30

Does this product need a PC6 or FC to be used? View answer

Answer posted 1 year ago

Question 31

Your Question: I've got a turbocharged Hayabusa 2002. Is this ignition module compatible with the Power Commander V for the Hayabusa 2002 - 2007 Turbo (20-023-PTI) and with my bike? View answer

Answer posted 1 year ago

Question 32

Does this coil need to be bolted with standoffs and to the frame? I am looking to replace my OEM coil on my 1976 KZ400 as well as moving the location of it, but the place that I found that will be perfect is not a section of frame or connected to the frame. View answer

Answer posted 1 year ago

Question 33

Do I need to buy 2 kits for my Marauder VZ800, or does one kit come with the parts for both carburetors since the motorcycle has 2? View answer

Answer posted 1 year ago

Question 34

I just purchased a pv4 for can am outlander 850 xmr and was wondering if I can get a custom tune made View answer

Answer posted 1 year ago | Power Vision 4 for Can-Am X3 Pinout

Question 35

The end piece that threads on to the wastegate where it connects to the turbo has broken on my dynojet waste gate. How might I go about getting a replacement? Is there a part # I can order it? It looks like it has now been upgraded to a heim joint on the ones you now sell. View answer

Answer posted 1 year ago

Question 36

Where do i find tunes for aftermarket pipes and snorkels View answer

Answer posted 1 year ago | Power Vision 3 for Can-Am Outlander

Question 37

2023 maverick x3 xor turbo rr 64" with 35" tires.will it work for it? View answer

Answer posted 1 year ago

Question 38

Does the kit come with parts for all four carbs? Or do I have to buy four kits? View answer

Answer posted 1 year ago

Question 39

Hi. I have bought an power commander V for my 1999 Hayabusa, but there is round white connectores on the bike, but square black connector on the PW. What to do? View answer

Answer posted 1 year ago

Question 40

Hi , What about STAGE 3 KIT FOR INDIAN THUNDERSTROKE 111/116 ?Not in stock now , soon available ?Delivery for France possible ?Best regards Olivier View answer

Answer posted 1 year ago

Question 41

Hi, mostly interested because I might get a 180 or 200cc kit and bigger injector for it in the future. My questions - there seems to not be any maps related to bigger cc engines as downloads, will I be able to create a full map for these bigger cc's since I'm only limited to 15% adjustment in fuel? Or do I have to keep adding fuel and create a new map as base map until I get to were I need to be? Does the pc6 alow me to manipulate ignition timing? I know I can create a fuel compensation map off of a 0-5v analogue pressure sensor input in the manifold but can I xxxx timing well? The bike in question is a '11 yamaha yzf-r 125. View answer

Answer posted 1 year ago

Question 42

Does it come ready to install? View answer

Answer posted 1 year ago

Question 43

Does this adaptor work with the snap on solus plus scan tool? View answer

Answer posted 1 year ago

Question 44

Can this be used to bleed the ABS module through the ECM? View answer

Answer posted 1 year ago | Power Vision 4 for 2021 Harley Davidson

Question 45

What size Jets come in the Klx 110 jet kit?? View answer

Answer posted 1 year ago | Jet Kit for 2010-2023 Kawasaki KLX110

Question 46

Is the tuner water proof? Does it have warranty? And if I were to install it now without an aftermarket exhaust and install one later would the tune be good to run or would I have to re tune it? View answer

Answer posted 1 year ago

Question 47

Your quick shifter run on FXLRS 2020 ? Should we install another module (as power commander) ? It works with mid control ? View answer

Answer posted 1 year ago | PCIIIUSB HD QS Sensor Kit,99-08,Softail

Question 48

I have a power commander three in my 2006 ultra classic I cannot figure out why my rear cylinder is running really hot. I mean really hot. It is duals with Rhineharts. When I look at my setting on my power commander it looks like it?s lean 00 at low, but I can?t make any adjustments to this xxxx thing anybody help View answer

Answer posted 1 year ago

Question 49

Can I use 2,2ohm coils with the dyna S? View answer

Answer posted 1 year ago

Question 50

Is this ignition module self-grounding? I blew the stock ignition module and switched over to points. Which had grounding issues. Just want to get this squared away before I install it. View answer

Answer posted 1 year ago

Browse by Topic