Question 1

Is this compatible for a 2023 honda grom? With the power vision 3 of course. I already have a Yoshimura Race RS-9T Stainless Full Exhaust on the bike. As well as a cool air intake. View answer

Asked 2 ´years ago

Question 2

Power commander 5 installed on a USA, California 2014 Yamaha yzf-r6 this is my track bike. Mod list is ais removed, smog block offs installed, servo buddy, Csracing full exhaust, db killer removed, k&n air filter, o2 sensor removed and plugged. No map available for this set up. Question, what map on your list would be best to use if a custom map for my set up can not be made? Tia View answer

Asked 2 ´years ago

Question 3

What is the thread size for these sensors? View answer

Asked 2 ´years ago

Question 4

Can I also use a PV3-16-01 (instead of PV3-16-02) also for my Honda Monkey 2019? View answer

Asked 2 ´years ago

Question 5

Would it still run if the wires are not wired corectly and what if I wired it for dual fire when it should be for single View answer

Asked 2 ´years ago

Question 6

can i use this pc 6 with auto-tune pn AT-110b View answer

Asked 2 ´years ago

Question 7

When will they be back in stock View answer

Asked 2 ´years ago

Question 8

I just installed this on a 1980 cb750 custom build. What are the white, dark blue, and purple wires with bullet connectors for? There's no mention of them in any wiring diagram or manual I can find. Also I get 12v to the system, but the test light keeps blinking and makes it impossible to do the static timing outlined in the instructions. View answer

Asked 2 ´years ago

Question 9

Hi, Will this work on cb500x 2022 model? View answer

Asked 2 ´years ago

Question 10

Would this kit pair still with a powerbomb fmf exhaust and muffler? Stock engine , Af, and air box View answer

Asked 2 ´years ago

Question 11

Can I remove speed limiter on my Yamaha MT-09 Tracer 2018year with this device? View answer

Asked 2 ´years ago

Question 12

how do I determine which carb jet kit I need? It says in the Installation guide I need to figure out which arb I have on the bike for the THUNDERSLIDE JET KIT FOR HARLEY-DAVIDSON TWIN-CAM 88 44MM View answer

Asked 2 ´years ago

Question 13

Will this option downshift too View answer

Asked 1 ´year ago

Question 14

Can ignition timing be adjusted on a 2017 Polaris Sportsman 570 EPS with the Power Commander Fuel Controller? View answer

Asked 1 ´year ago

Question 15

What is the required tuning? Is that just to set the RPM to match the clutch engagement? I really dont want to change my tune. But I understand tuning the launch control. View answer

Asked 1 ´year ago

Question 16

Can the temperature the cooling fan turns on be adjusted on a 2017 Polatis Sportsman 570 EPS with the Power Commander V? View answer

Asked 1 ´year ago

Question 17

Can ignition timing be adjusted on a 2017 Polaris Sportsman 570 EPS with the Power Commander V? View answer

Asked 1 ´year ago

Question 18

What is the length and number of cables?Thanks View answer

Asked 1 ´year ago

Question 19

I have a PV-1 and I now have a 2019 Triglide. Will my pv1 work on my Triglide with a 4 pin cable and a 6 pin adapter. View answer

Asked 1 ´year ago

Question 20

Does the PC6 for the Honda 954RR (SKU PC6-16048) have an adjustable ignition map or just fuel? View answer

Asked 1 ´year ago

Question 21

Hello, I have a ninja 400 2021 and u was wondering if this product works on my bike. View answer

Asked 1 ´year ago

Question 22

Hello, I have a ninja 400 2021 and I was wondering if this will work with the bike? View answer

Asked 1 ´year ago

Question 23

Will it a fit 2016 kx450 View answer

Asked 1 ´year ago

Question 24

Hello, is this sensor compatible with Power commander 3 USB? View answer

Asked 1 ´year ago

Question 25

Looking to fit my dyno jet SN230201019861 ,for a handlebar mount. Would conect to a Harley Davidson 2019 Road King Special View answer

Asked 1 ´year ago

Question 26

Hello,I have a question about the DRL Magneto 300 CDI Kit. Is it possible to run the rev limiter without a battery? I have an old race bike with a Kr�ber magneto ignition without battery or anything similar. Is there a wiring manual or instruction manual available so that I could check if it would fit?Best regards,Robin View answer

Asked 1 ´year ago

Question 27

I lost my instructions just wondering where I can find them View answer

Asked 1 ´year ago

Question 28

On Thruxton R, is ignition timing adjustable? View answer

Asked 1 ´year ago

Question 29

will this replace my cdi box under triangle cover behind seat on 1989 harley 883 . i just install under nose cone and wire direct to appropiate connections ? View answer

Asked 1 ´year ago

Question 30

Does this PC fit the MT10 2022 ?? View answer

Asked 1 ´year ago

Question 31

I just installed the Dynatek TC88 ignition on my 2003 Dyna Superglide. The bike has a Kerker 2 into 1 exhaust, modified CV carb, Ness Big Sucker intake, and S&S 509c cams. What would be the recommended ignition curve to start with? Thanks View answer

Asked 1 ´year ago

Question 32

Works with Indian Sport Chief 2023? View answer

Asked 1 ´year ago | InVision Monitor Device for Indian Motorcycle MG1

Question 33

2023 Can Am Outlander max xt 1000rpower vision 3 or 4? Both say compatible? View answer

Asked 1 ´year ago | Power Vision 3 for Can-Am Outlander

Question 34

can this liscence unlock a tune that is allready on the pv3 for canam ryker View answer

Asked 1 ´year ago

Question 35

My bike was dyno?d with a new cam on stock O2s last summer. Would widebands and target tune give me any better performance and would this be safe to do? View answer

Asked 1 ´year ago

Question 36

I am doing a 2007 XL1200C EFI to Carb Swap, will this ignition work? View answer

Asked 1 ´year ago

Question 37

I?m looking to purchase a complete kit to add onto my cbr 600 f4i do I need to just buy the dual sensor and shift rod b ? And everything will work then or what ? Thanks again ! View answer

Asked 1 ´year ago

Question 38

Can this remove the rpm restrictions? View answer

Asked 1 ´year ago

Question 39

Hellocan i command this for France, no more sellers for this parts in my country....how i can buy it?Thanks View answer

Asked 1 ´year ago

Question 40

My original CDI has 3 cables attached and this box only has 2 ports will it work on my 2006 grizzly 660 View answer

Asked 1 ´year ago

Question 41

How how exactly does the wiring for the injectors work? If I'm using this product on a 4 cylinder engine will I have to solder a different hardness to make it compatible? View answer

Asked 1 ´year ago

Question 42

Does it fit CRF 300 rally EURO model? (ecu part number 38770-K1T-E11) View answer

Asked 1 ´year ago

Question 43

I have a 1974 fx with STD dual plug heads.(didn't order dual but that's what they sent) Been running as single with points for 20yrs. Tried duals coils years ago but the condenser couldn't keep up. What coils would I need with this ignition I see your single fire needs 5ohm coils. What coils will this dual fire use? View answer

Asked 1 ´year ago

Question 44

Do you have any solution that works with the EU ECU of the CRF300L? View answer

Asked 1 ´year ago

Question 45

I have this unit on my 2022 KLX300R. Can you tell me if it's controlling only fuel, or fuel and ignition ? View answer

Asked 1 ´year ago

Question 46

How long a duration of data can be logged in the POD-300 and can that data be exported to Excel, Matlab, etc? View answer

Asked 1 ´year ago

Question 47

When the throttle commander will be available for can am 2023 View answer

Asked 1 ´year ago

Question 48

Which ignition coil should be purchased for use with this on a 77 kz650? I want to make sure I have the right ohms. View answer

Asked 1 ´year ago

Question 49

I have a PV-1B. will firmware update, new license, and this cable let it communicate with my 2021 low rider s View answer

Asked 1 ´year ago

Question 50

I would like to have the assembly instructions as for the power command V. Thanks View answer

Asked 1 ´year ago

Browse by Topic