Question 1

Could you guys tell me which parts (part numbers) I need to install the QS in my bike, it's a Kawasaki Z900 2020, I already have the PCV, but I need to know all parts that I need to install the QS please, thanks! View answer

Asked 4 ´years ago

Question 2

Hi, does this come with O2 Sensors, and what exactly will this do to my bike with only 1 tune available? Does it come pre programed? Do I need to do anything to it prior to installation, or can I just plug and play with a noticeable difference? View answer

Asked 3 ´years ago

Question 3

I have a 2023 KRX4 100 Special edition. I have the tune installed and am trying to adjust my clutching accordingly. What RPM should I be aiming for with this tuner? I am running adjustable weights, so just need a rough idea of what this tune is built around. Stock exhaust, stock intake. View answer

Asked 3 ´years ago

Question 4

I have the power vision 3 for my 18 scout. I am installing bassani 2-1 pipes and a s&s intake. My question is: do I need to delete the o2 sensors? If I leave them in does it take away from the tune? View answer

Asked 4 ´years ago

Question 5

Since there is not a kit specifically for the Honda CB1000C,would it be better to use the CB900C kit with 126 or 130 main jets or the CB1100F stage 1 kit 120 or 124 because of the needle differences? Or do I just have to trial and error? I ask because the instructions for the CB750C/CB900C seem to be written with only the CB750 in mind as far as the jets, as it mentions a different drill for slide holes,but the jets it suggest are 96 & 100 when the stock jet on the 900 is a 105, so the stock jet on the CB1000C being a 110 has me really wondering which kit to use. View answer

Asked 3 ´years ago

Question 6

Why isn't there a one vehicle option? View answer

Asked 4 ´years ago

Question 7

Do you ship to CA? View answer

Asked 3 ´years ago

Question 8

tengo una road king 2019 motor 107 con un kit power vision PV-2B puedo montar este kit target tune , si es asi se me abriran mas menus en el power vision.gracias un saludo. View answer

Asked 4 ´years ago | Target Tune Full Kit for Harley-Davidson Touring / Trike Models

Question 9

Can this ignition module work on the 2021 YXZ1000R SS as well? View answer

Asked 3 ´years ago

Question 10

Is this comparable with the 2021 RoadGlide Limited? View answer

Asked 4 ´years ago | POWER VISION FOR 2021+ HARLEY-DAVIDSON

Question 11

I have a PV3-25-04 for canam will this tune work on it for this outlander? Pretty sure the ecm hook ups are the same View answer

Asked 3 ´years ago

Question 12

Will this tuner void my warranty if I use 1 of your tunes? View answer

Asked 3 ´years ago | Power Vision 3 for 2021 Harley-Davidson MT22 ECU

Question 13

If I already own a stage 1 intake OEM for a 2019 Indian Chieftain Classic would I need to use the intake lid and reinstall the original intake? View answer

Asked 3 ´years ago

Question 14

I want to connet a Dyna D6-4 to a Crane HI-4 ignition system . I need to know what the 3 wires represents ( red , white and blue ) Waht?s + , - etc. View answer

Asked 4 ´years ago

Question 15

HI. Does this fit EU version of 2022 honda grom ecu? View answer

Asked 3 ´years ago

Question 16

Can you lower idle speed with this? View answer

Asked 4 ´years ago

Question 17

Will this product still fit if I have a S&B particle separator installed on my 2022 Razr Pro XP 4 Ultimate? View answer

Asked 3 ´years ago

Question 18

I?m looking to get an HMF Preformance slip on exhaust for my can am outlander 650 xmr. Will there be a preset tune for a hmf exhaust on the tuner when I hook it up to the computer or will I have to create my own tune for the hmf slip on exhaust? View answer

Asked 4 ´years ago

Question 19

Have black widow full exhaust. Is there a tune for that exhaust.If not what would your recommend? View answer

Asked 4 ´years ago

Question 20

Can wide band oxygen sensors be used to tune with this product? View answer

Asked 3 ´years ago | Power Vision 4 for 2021 Harley Davidson

Question 21

This says ?full kit?, does that mean I wouldn?t have to buy any other products to use this on my 2008 heritage softail classic? View answer

Asked 4 ´years ago | Target Tune for Harley-Davidson J1850 ECU 52/10'' 2P

Question 22

Is it the same for the honda crf 250L and the crf 250L ABS?All the crf250L have ABS.Thank you View answer

Asked 3 ´years ago

Question 23

What size jets are included in this kit? i am looking for a 220 - 180 main jet. View answer

Asked 4 ´years ago

Question 24

Can i run this on my 1990 sportster with out the VOES? View answer

Asked 3 ´years ago

Question 25

Can these be used with the Dynatek DC1-1 3 ohm coils? View answer

Asked 3 ´years ago

Question 26

Please provide dimensions for the DC 1-1 coil and recommended clearance between the two coils. View answer

Asked 3 ´years ago

Question 27

When will there be a commander for the new Honda KF47 157cc 4 valve engine that comes in the 2022 Honda PCX? View answer

Asked 3 ´years ago

Question 28

Hi, I have the 690 Enduro R, 2021 EU model (Euro 5) with Rade Garage filter and intake plus the the Wings muffler and the Powercommander 5 using the 18-030-003.1 Map (the map has ktm 690, 2019 in its notes) from your website. No other dongle or mod is made. It does not run well under acceleration full throttle where it hits a spot on the higher revs where the engine abruptly loose power before it may pick up power and continue to rev up. I have seen statement on forums that the PC5 would not work on EUR5 models 690. Could you verify that this hardware and map should work fine? All connectors matched perfectly. View answer

Asked 4 ´years ago

Question 29

I watched the install video on YouTube and the guy said it was important to ensure the can termination plug was installed. I can't seem to find mine and the pdf directions don't mention it anywhere. Do I need this piece? https://youtu.be/9pf-c52kbFU?t=124 View answer

Asked 3 ´years ago

Question 30

2022 models not listed in fitment. Is this compatible with 2022 models? View answer

Asked 3 ´years ago

Question 31

Once installed the check engine light came on and I have a full yoshi system with a duel twin air filter and the only tune for this bike is stock exhaust and filter so idk if it would even do anything View answer

Asked 4 ´years ago

Question 32

Does it do anything with torque limiters, seatbelt , speed limiters (high , low , rev)? Can you put back to stock? View answer

Asked 4 ´years ago

Question 33

I have a 2009 Brute Force 650i with a Moose Racing power module I plugged in 10 years ago. Will this Dynatek module improve power and performance over the one I already have? View answer

Asked 4 ´years ago

Question 34

I'm really interested in the POWER VISION 3 FOR 2017-2021 POLARIS RANGER 500/570. I have a 2015 POLARIS Ranger 570 efi crew with the 8 pin diagnostic connector with the 2015-2017 Ranger 570 eps Chassis Wire Harness OEM part number 2412701 . OK IM saying the wire harness and sensors and ECU, fuel injector, Engine parts all have same oem part numbers as the 2017 Ranger 570 EPS in your Fitment list. WILL the POWER VISION 3 work for me ? thanks View answer

Asked 3 ´years ago

Question 35

I'm interested in this item. Actually I've a 2007 Yamaha FZ1 with a PCV and autotuner paired. Next step for me is quick shifter, looking for pressure push and pull type V2.0 but it not fit in my bike? I don't not why?? because you have in your fitments table the Yamaha Fz6 and Fz8 I hope you can help meThanks View answer

Asked 3 ´years ago

Question 36

Does this work with the PCV + autotune? View answer

Asked 3 ´years ago

Question 37

Does this connect to the power commander 5 for gsxr 600 k4? View answer

Asked 3 ´years ago

Question 38

What is the difference between the PC6-20023-PTI and the PC6-20023 View answer

Asked 3 ´years ago

Question 39

is it compatible with PV-2B or have to buy a nex box ? View answer

Asked 4 ´years ago

Question 40

Is this kit compatible with DR350s that have the 440cc big bore kit? View answer

Asked 4 ´years ago

Question 41

2021 cbr650r absI can only find the power vision.I was hoping to install a power comander 5 or 6 and auto tune like I did on my last bike. Do you plan on making one for this model? View answer

Asked 3 ´years ago

Question 42

Can I run this on a S&S motor ? View answer

Asked 3 ´years ago

Question 43

States the Power vision is good for model years 2021-2022. Won?t allow me to pick my 2022 Road Glide special. Any idea on when 2022 mapping will be available? Thanks View answer

Asked 4 ´years ago | POWER VISION FOR 2021+ HARLEY-DAVIDSON

Question 44

Will this fit a 2007 Kawasaki zx14 and will it fit a 2009 Kawasaki zx10 View answer

Asked 3 ´years ago

Question 45

Why is the full warranty disclaimer not posted? What all does the load time warranty cover? Is there any warranty fee when belt replacement is needed? View answer

Asked 4 ´years ago

Question 46

Can you change rpm rev limit or timing curves for 2018-2022 Suzuki Z-50 quadsport models? If so how is this accomplished? Thank you View answer

Asked 3 ´years ago

Question 47

Can this be used to autotune? With the standard OEM narrowband? View answer

Asked 4 ´years ago

Question 48

Does this get rid of the 48mph speed limit on a 2020 sportsman 1000 highlifter? View answer

Asked 4 ´years ago

Question 49

Hello, will there be a power commander for the segway villain 1000cc utv? View answer

Asked 3 ´years ago

Question 50

I ordered and installed this ignition on my 76 gl1000, followed all the instructions but I am having issues timing it. I hooked up the test light and timed it as the instructions say. Test light fires at F2 when connected to the blue wire and fires at F1 when connected to the yellow, but it also fires and will stay on at other points in the engines rotation. Tried to fire the bike up and it will start but will not go above 1,000 rpm and dies when I let off the throttle. Is it possible I have a faulty module? View answer

Asked 3 ´years ago

Browse by Topic